Unitron MEC2 Spécifications télécharger pdf (Page 9)

MEC2 INVERTED METALLURGICAL MICROSCOPE

UNITRON

73 Mall Drive, Commack, NY 11725 • 631-543-2000 • www.unitronusa.com 9

Connecting the Power Cord

(Figures 12, 13 & 14)

The electric cord should never be bent,

twisted, crushed or subjected to stress.

1. Set the main switch① to “O” (off) before

connecting the power cord.

2. Insert the power cord into the receptacle②.

3. Insert the BNC cord plug (3) into the BNC

connector (4).

Ensure the power cord is connected to a

properly grounded electrical outlet.

Replacing the Fuse (Figures 12 & 13)

Ensure the main switch① is set to “O” (Off) and

the power cord is disconnected before replacing

the fuse. With a flat-head screwdriver, remove

the fuse holder (5), replace with a new fuse,

then re-install the fuse holder.

Fuse rating: 250V, 500mA

Connecting the Power Cord

(Figure 14)

Insert the power cord (6) into a properly

grounded 3-prong electrical outlet (7).

Fig. 12

Fig. 13

Fig. 14

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Unitron MEC2 Spécifications Page 9